TORK CRAFT Blade Contractor Alum 160 X 60t 20/16 Circular Saw Tct

Features

• 160mm diameter blade Gives sufficient cutting depth for sheet aluminium, profiles and common joinery tasks.
• 60T carbide-tipped teeth High tooth count ensures fine-finish cuts in aluminium and light alloys.
• 20/16mm bore configuration Broad compatibility with circular saws used in site or workshop environments.
• Contractor Series build quality Professional-grade construction to handle frequent use in demanding environments.
• Optimised for aluminium cutting Tooth geometry and blade design tailored to non-ferrous metals rather than standard wood-cutting tasks.

Benefits

• Exceptional edge finish: The 60-tooth layout delivers clean, burr-reduced cuts in aluminium with less post-processing.
• Dependable performance: Built for the demands of contractors and tradespeople working with light metals, offering consistency and durability.
• Tool-fleet compatibility: The 20/16mm bore means you can use the blade across different circular saws without swapping accessories.
• Reduced downtime and rework: Smoother cuts and fewer imperfections mean less time spent finishing or correcting edges.

Extra Information

• Designed specifically for aluminium and non-ferrous metal cutting — not typical hardwood or deep timber cuts.
• Well-suited to fabrication shops, aluminium joinery, metal trim installation, skylight framing, curtain-wall prefabrication and similar tasks.
• Ensure your saw is rated for the blade diameter and check maximum RPM, particularly when cutting metal—non-ferrous cutting has different demands to wood.
• To extend blade life, clean off aluminium swarf and oxide build-up after each session, use a proper metal-cutting lubricant or dry-cut as recommended, and store the blade safely when not in use.

Specifications

Safety

• Wear eye, ear and dust/metal-chip protection when cutting aluminium to guard against flying chips, oxide particles and noise.
• Always disconnect the saw from power before changing or adjusting the blade.
• Ensure the blade is mounted correctly, the rotation arrow matches the saw’s direction, and the flange and guard are secure.
• For metal-cutting use, ensure proper airflow and dust/chip extraction — aluminium chips can burn, stick and cause hazards if accumulated.
• Allow the blade to reach full speed before entering the cut and wait until it has completely stopped before handling the saw or workpiece.