AIRCRAFT Rear Splint Integration For Comp 05 & 07

Features

• Rear plate / end plate component Designed to support the rear section of the mini compressor assembly.
• Integrated sealing ring Seal sits in a groove to help prevent pressure leakage between surfaces.
• Multiple mounting holes Allows secure fastening and correct alignment during assembly.
• Model-specific fitment Listed for AirCraft Comp 05 and Comp07.

Benefits

• Helps prevent air leaks: A correct seal helps maintain pressure and consistent performance.
• Restores proper alignment: Supports correct assembly fit, reducing vibration and uneven wear.
• Improves reliability: Reduces the chances of “mystery” pressure loss caused by poor sealing surfaces.
• Ideal for rebuilds: Perfect replacement part when servicing worn, damaged, or warped plate components.

Extra Information

• Compatibility: Intended for AirCraft Comp 05 and Comp07 mini compressors.
• Inspect mating surfaces: Clean and check the contact faces—scratches and debris can cause leaks even with a new seal.
• Check the seal condition: If the sealing ring is nicked, flattened, or stretched, replace it to ensure a proper seal.
• Even tightening: Tighten fasteners evenly in a cross pattern to avoid distorting the plate.

Specifications

Safety

• Disconnect power (and remove battery if applicable) before disassembling the compressor.
• Allow the unit to cool down before opening covers—mini compressors can get hot during use.
• Work in a clean area to prevent dust entering internal parts and sealing surfaces.
• Avoid using sharp tools near the sealing ring—cuts or nicks can cause immediate leaks.
• After assembly, test the unit carefully and check for abnormal noise, vibration, or pressure loss.