Replacement 13mm Collet For Ms2001

How to Use

• Make sure the MS2001 sharpener is not connected to a power drill before replacing any part.
• Inspect the sharpener and identify the original 13mm collet that needs to be replaced.
• Remove the worn, damaged or missing collet component according to the MS2001 sharpener instructions.
• Clean the surrounding area to remove dust, debris and abrasive particles.
• Fit the MS2011 replacement 13mm collet into the correct position.
• Check that the collet is seated correctly and that the related holding components tighten and release as intended.
• Reassemble the sharpener fully before use.
• Test the sharpener gently on a suitable drill bit setup, using light pressure and correct operating technique.